<%NUMBERING1%>.<%NUMBERING2%>.<%NUMBERING3%> PRTG Manual: Redfish Power Supply Sensor

Credentials

This sensor requires credentials for Redfish in settings that are higher in the object hierarchy.

IPv6

This sensor supports IPv6.

Performance impact

This sensor has a very low performance impact.

Lookups

This sensor uses lookups to determine the status values of one or more channels.

Limits

This sensor has predefined limits for several metrics.

Redfish support

Supporters of the Redfish standard include Dell, Eaton, Emerson, Fujitsu, HPE, Intel, Lenovo, NetApp, Supermicro, and VMware.

Multi-platform probe

You can add this sensor to a multi-platform probe.

Name

The name of the power supply that this sensor monitors.

Model

The model of the power supply that this sensor monitors.

Manufacturer

The manufacturer of the power supply that this sensor monitors.

Serial Number

The serial number of the power supply that this sensor monitors.

Primary Channel

Select a channel from the list to define it as the primary channel. In the device tree, PRTG displays the last value of the primary channel below the sensor's name. The available options depend on what channels are available for this sensor.

You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab.

Graph Type

Define how this sensor shows different channels:

• Show channels independently (default): Show a graph for each channel.
• Stack channels on top of each other: Stack channels on top of each other to create a multi-channel graph. This generates a graph that visualizes the different components of your total traffic.
  You cannot use this option in combination with manual Vertical Axis Scaling (available in the channel settings).

Stack Unit

This setting is only visible if you select Stack channels on top of each other above.

Select a unit from the list. PRTG stacks all channels with this unit on top of each other. By default, you cannot exclude single channels from stacking if they use the selected unit. However, there is an advanced procedure to do so.

Result Handling

Define what PRTG does with the sensor result:

• Discard result (default): Do not store the sensor result.
• Store result: Store the last sensor result in the \Logs\sensors subfolder of the PRTG data directory on the probe system. The file name is Result of Sensor [ID].log. This setting is for debugging purposes. PRTG overwrites this file with each scanning interval.

This option is not available when the sensor runs on the hosted probe of a PRTG Hosted Monitor instance.

In a cluster, PRTG stores the result in the PRTG data directory of the master node.

Downtime

In the channel table on the Overview tab, this channel never shows any values. PRTG uses this channel in graphs and reports to show the amount of time in which the sensor was in the Down status

Input Voltage

The input voltage

Input Watts

The input watts

Output Load

The output load

This channel has default limits:

• Upper error limit: 99%
• Upper warning limit: 90%

Output Watts

The output watts

Power Efficiency

The power efficiency

Power Supply Status

The power supply status

• Up status: OK
• Warning status: Warning
• Down status: Critical
• Unknown status: Offline / Absent

This channel is the primary channel by default.